Publicidad
Idiomas disponibles
Idiomas disponibles
USING YOUR BEER DISPENSER
9. Hooking up the keg coupler to the keg: Verify the cou-
pler is in the "OFF" position (see Figure 31a).Align the
lugs on the keg with the corresponding openings on the
keg coupler and turn clockwise until the coupler stops
(about 90°). Push down and twist the top of the coupler
clockwise to allow gas to enter the keg.
Push faucet handle back toward
tower to close the faucet
Figure 30
Lugs
on keg
Figure 31b
14
CARE AND USE/INSTALLATION
All manuals and user guides at all-guides.com
Chain-The chain is fastened and taped
to the top of the interior liner. Remove
the tape and secure the CO
place in the back right corner. Loop
chain around top of tank and connect
tank in
2
with "S" hook.
Rotate the top of the coupler coun-
ter clockwise to extend the coupler
to the to the "OFF"position.
Figure 31a
Figure 31
Connect
with "S"
hook
Figure 30a
Coupler
extended
Publicidad
