CONTROLS
Appliance controls- single and dual zone
The control panel is shown in figure 4. For reference it is also shown below:
Single zone
Dual zone
– Power button
– Light button
– "+" button
– "-" button
To switch the power on/off
Press and hold the power button for one second to switch the wine cooler on.
Press and hold the power button for five seconds to switch the wine cooler off.
To change the temperature
•
Press the "+" or "-" buttons until the required temperature is shown on the display.
•
The Preset temperature is 12˚C / 54˚ F. (for single zone models)
•
For dual zone models: For the upper/left zone, the default temperature set-
ting is 8°C/46°F, and for the lower/right zone, the default temperature setting is
12°C/54°F.
•
To view the set temperature, touch the "+" or "-" button at any time and the set
temperature will flash in the LED display for five seconds.
•
The display shows the current internal temperature when the wine cooler is on.
Note: The temperature in the lower zone must be set either the same as or higher
than the temperature in the upper zone.
Optimal temperature selection
Whilst wine is best stored at temperatures between 13 and 15˚ C, your wine can also
be stored at drinking temperature. For red wine this is between 15 and 17˚C, and for
white wine between 12 and 13˚C.
40