Operating Modes; Normal Mode - SEAL 62 Base Manual De Uso

5.2

Operating modes

The machine is either in normal mode, or slow mode. In both normal and slow mode the rollers can
rotate in forward or in reverse direction.

5.2.1 Normal mode

When slow mode is not activated (normal mode), the rotation speed of the rollers is set via the
speed control knob.
Start rotation by pressing the forward button, the reverse button or the footswitch.
Rotation stops when a stop button is pressed or the footswitch is released.
Note:
To return control from the footswitch to the control panel without stopping, press and hold the
forward button, release the footswitch and then release the forward button.
An interruption of the light beam of the optical safety device in front of the rollers will also stop the
rotation of the rollers. To continue after the interruption is taken away, the process must be started
again.
Reverse
WARNING:
KEEP CLEAR OF THE REAR SIDE NIP WHEN RUNNING IN REVERSE MODE.
When running in reverse, the optical safety device at the front side nip is ignored. An audible tone
is heard to warn you for posible danger.
The speed is determined by the speed control.
18 User Manual 62Base