Slow Mode - SEAL 62 Base Manual De Uso

5.2.2 Slow mode

Enter or leave Slow mode by pressing the slow mode button for 1 second. The selection is
indicated by the slow mode indication LED.
Entering slow mode will not change anything to the current movement of the rollers.
In slow mode the rollers can run at normal or at slow mode speed.
Normal speed
Press the forward or reverse button in slow mode to run at a normal speed determined by the
speed control setting (see normal mode).
To start at slow mode speed or to switch from normal (forward) to slow mode speed just press and
hold the footswitch (when slow mode is selected).
Slow mode speed
Press and hold the footswitch in slow mode to force the rollers to run forward at a fixed low speed
(see specifications) independent from the speed control.
Slow mode speed is always running in forward direction. Slow mode speed in reverse direction is
not possible.
WARNING:
KEEP CLEAR OF THE NIP WHEN RUNNING AT SLOW MODE SPEED.
When running at slow mode speed, the optical safety devices are ignored and an audible signal is
heard to indicate danger.
When the footswitch is released, the forward rotation is stopped.
Note:
To change from slow mode speed to normal speed without stopping, press and hold the start
button, release the footswitch and then release the start button.
Changing to normal speed will not deactivate slow mode.
Pressing the footswitch again will slow down rotation to slow mode speed again.
Operating 19