Genie LA 500 A3 Manual De Instrucciones página 8

EN INSTRUCTION MANUAL
Dear customer,
Thank you for buying this high-quality product. Please carefully read through
these operating instructions before using the device for the first time. In
particular, please comply with the safety notices. Our service information is
located at the bottom of these instructions.
Intended Use
The laminator is only suitable for laminating documents. Any other use or
modification shall be deemed to be improper and involves substantial risk of
accidents.
Scope of Delivery
Laminator GENIE LA 500 A3
Instruction manual
Information:
The included laminating pouches can only be used for hot laminating! Laminating
pouch strength is 80 Micron.
Important advice about safety
1. Read through these operating instructions carefully and completely before
using the machine for the first time.
2. Only put the machine on a flat and dry surface. It must be freely accessible
from all sides. It is not recommended to use an extension cable!
3. Do not open or repair the laminating machine yourself but take it to your
specialized dealer whenever it is damaged, or contact our service hot line.
4. Only use films of the correct size (up to DIN A3 max.) and thickness (80 to 125
microns). Films that are too thin cause a blockage of the film in the machine.
5. Do not touch the hot surface of the machine after it has started up.
6. The laminating machine is not allowed – for safety reasons – to be used by
children, unless they are supervised by an adult.
7. Never use the machine in the open air or near water.
8. Hot lamination: do not laminate in this mode any materials that are sensitive to
heat with this machine, like thermo-fax paper for example. These materials are
only suitable for cold lamination.
9. Do not pour or spill any liquid into the machine or onto it.
10. Do not insert any metal objects into the machine. Please do not grasp inside
the machine with your fingers.
11. The laminating machine is unsuitable for constant use commercially. It is
recommended to switch off the machine for 30 minutes, after it has been
operating for a period of approximately 30 minutes.
8