Genie LA 500 A3 Manual De Instrucciones página 9

12. The socket should be near the device and easily accessible.
Description of machine components
A Insert opening
B Controller 80 micron/ ABS (OFF)/ 125 micron
ABS: Antiblocking system or jam release
C Power/ Ready
D Hot/ Cold
Hot laminating ('Hot')
1. Push the plug into the mains socket outlet and set the switch to 'Hot'. The
Power LED lights up and the heating process will begin.
2. The Ready LED lights up after approximately 5 minutes. Now you can begin
the laminating process.
3. Open the laminating film and lay the material that is to be laminated directly
onto the closed side. Leave a margin of between 3 mm and 5 mm
approximately beyond the edges while doing so.
Caution
a) Choose a film of correspondingly suitable size in relation to the material that is to
9