Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Problem
The line does
Lines are welded to
not advance.
themselves.
Not enough line on
spool.
Lines are worn too
short.
Lines are tangled on
spool.
The line
The machine is used
keeps break-
incorrectly.
ing.
Grass winds
Cut tall grass at ground
around the
level.
trimmer head
and motor
housing.
The line does
The cut-off knife
not cut well.
becomes dull.
Heavy
The length of line on
vibration.
one side is longer than
the other side.
28
Possible Cause
Solution
Lubricate with silicone spray.
Install more line.
Advance the cutting line.
1. Remove the lines from the spool.
2. Wind the lines.
1. Cut with the tip of the line, avoid
stones, walls and other hard objects.
2. Advance the cutting line regularly to
keep full cutting width.
1. Cut tall grass from the top down.
2. Remove no more than 8" in each
pass to prevent wrapping.
Sharpen the cut-off knife with a file or
replace it.
Make sure that the line on both sides
is equal in length. Advance the line.
© 01/2023 ECHO Incorporated
DSRM-2100
99922238008
Publicidad
