Publicidad
Idiomas disponibles
Idiomas disponibles
3.
4.
Using bar tool, roll chain around guide bar
to ensure all tinks are in bar groove.
Lift up tip of guide bar to check for sag.
Release
tip of guide
bar, then turn ad-
justing screw 1/4 turn clockwise.
Repeat
until sag does not exist.
Adjusting
Screw
- 1/4 Turn
While lifting tip of guide bar, tighten
bar
nuts securely
with the bar tool.
Bar Nuts
KNOW YOUR CHAIN SAW
6.
Use the screwdriver
end of the bar tool
to move chain around guide bar.
7.
If chain
does not rotate, it is too tight.
Slightly
loosen
bar
nuts
and
loosen
chain by turning
the adjusting screw
1/4
turn
counterclockwise.
Retighten
bar
nuts.
8.
If chain is too loose, it will sag below the
guide bar.
DO NOT operate
the saw if
the chain is loose.
WARNING:
If the saw is operated
with a loose chain, the chain could jump off
the guide bar and result in serious
injury.
READ THIS
INSTRUCTION
MANUAL
AND SAFETY
RULES
BEFORE
OPERATING
YOUR
CHAIN
SAW.
Compare
the illustrations
with your unit to familiarize
yourself with the location
of
the various
controls
and adjustments.
Save this manual
for future reference.
Chain
Front Hand Guard
Front Handle
Adjustment
Tool
(Bar Tool)
_
Starter Rope
ON/STOP
Switch
Choke/
Idle
Chain
Muffler
Lever
Bar
Bar Oil Fill Cap
Sprocket
Hole
Primer Bulb
Starter Housing
Fuel Mix Pill Cap
Cylinder
Cover
X_
Chain
Chain
Throttle
Lockout
Brak -_
_.._'_
Direction
HandleRear
X_
Adjusting
Screw
_
of Travel
Throttle
Clutch Cover
Trigger
Bar Nuts
ON/STOP
SWITCH
The ON/STOP
SWITCH
is used to stop the
engine.
Guide Bar
Chain
Catcher
THROTTLE
TRIGGER
The THROTi-LE
TRIGGER
controIs engine
speed.
Publicidad
