Publicidad
Idiomas disponibles
Idiomas disponibles
TO LEVEL MOWER
Make sure tires are properly inflated to the
PSI shown on tires, lftires are overor under
inflated, it may affect the appearance ofyour
lawn and lead you to think the mower is not
adjusted properly.
VISUAL SIDE-TO-SIDE ADJUSTMENT
1. With all tires properly inflated and if your
lawn appears unevenly cut, determine
which side of mower is cutting lower,
NOTE: As desired, you can raise the low
side of mower or lower the high side.
2. Go to side of mower you wish to adjust.
3. With a 3/4" or adjustable wrench, turn
lift link adjustment nut (A) to the left to
lower the mower, or, to the right to raise
the mower.
Turn nut right
Turn nut left
to raise mower
lower mower
NOTE:
Each full turn of adjustment
nut will
change mower height about 3/16".
4. Test your adjustment
by mowing some
uncut grass
and visually
checking
the
appearance.
Readjust,
if necessary, until
you are satisfied
with the results,
PRECISION
SIDE-TO-SIDE
ADJUSTMENT
1. With alltires properly inflated, parktractor
on level ground or driveway.
_,
CAUTION:
Blades
are sharp.
Protect
your hands with gloves and/or wrap blade
with heavy cloth.
2. Raise mower to its highest
position,
3. At both sides of mower, position blade at
side and measure
the distance
(A) from
bottom edge of blade to the ground. The
distance should be the same on both sides.
4. If adjustment is necessary, see steps 2
and 3 in Visual Adjustment instructions
above.
5. Recheck measurements, adjustifneces-
san/until both sides are equal,
FRONT-TO-BACK ADJUSTMENT
IMPORTANT:
Deck must be level side-
to-side.
Toobtain the best cutting results, the mower
blades should be adjusted so the front tip is
1/8" to 1/2" lower than the rear tip when the
mower is in its highest position.
CAUTION: Blades are sharp. Protect
your hands with gloves and/or wrap blade
with heavy cloth.
• Raise mower to highest position.
• Position any blade so the tip is pointing
straight forward. Measure distance (B) to
the ground atfront and reartip ofthe blade.
o_
ea
• If front tip of blade is not 1/8" to 1/2" lower
than the rear tip, go to the front oftractor.
- With
an 11/16"
or adjustable
wrench,
loosen
jam nut A several
turns to clear
adjustment
nut B,
• With a 3/4" or adjustable
wrench,
turn
front link adjustment
nut (B) clockwise
(Itighten)
to raise the front of mower, or,
counterclockwise
(loosen)
to lower the
front mower,
l A
Tightenadjust nut
Loosen adjust
Bto raisemower
nut B to lower
mower
f
Loosenjam nut A first
NOTE: Each full turn of the adjustment nut
will change mower height about 1/8".
o Recheck measurements, adjust if neces-
sary until front tip of blade is 1/8" to 1/2"
lower than the rear tip.
• Hold adjustment nut in positionwith wrench
and tighten jam nut securely against ad-
justment nut.
26
Publicidad
