TRAPP TR-600 Manual De Instrucciones página 83

www.trapp.com.br
Feeding and shredding system
Before starting to work, make sure the machine
has reached maximum speed.
After properly directing the output device,
 
open the funnel cover.
Select the material to be shredded; do not
 
exceed maximum cutting length of ø10 cm.
Small branches can be shredded if placed
 
facing entry.
Do not push small branches with your
 
hands. Use long pieces of wood to do it. If
necessary, use an adequate device to push
the material.
Before inserting the material to be shredded
 
into funnel, remove different parts of wood
not to damage blades.
Output device adjustment
The direction of the output device jet can be
adjusted and turned 360
jet is adjusted with lever (A); the output position
with arm (B). To move it, loosen screw (C).
18
18
. The direction of the
O
Ground transportation
When transporting the machine by road,
 
follow the traffic code in force.
Storage
If your shredder has not been used for a long
period of time:
1. Wash it with a damp cloth and mild
detergent. Dry with a clean and dry cloth.
2. Inspect whole equipment, and replace
damaged/worn parts.
3. Firmly tighten all screws and nuts (see table
"Torque Specifications").
4. Lubricate and cover the whole equipment
with canvas. Keep it in a dry place, protected
from weather conditions.
Follow these instructions to always have your
shredder in good working conditions.
Attention!
Do not use a water jet to clean the
equipment. Water in the bearings can
damage them.
A
A
B
C
B
C
83