Black and Decker LSWV36 Manual De Instrucciones página 10

NOTE: Ensure the sweeper isswitched off a nd thebattery isremoved
from tool b efore attaching orremoving the vacuum t ubes. The vacuum
tube and collection bag must beassembled tothe housing before use.
Install battery after a ssembly just p rior touse.
• Attach t hecollection bag tothepower head asshown i nfigure
E
• Remove the fan cover from the side of the sweeper housing by
pressing the spring loaded release button (located on the lower right
side of the sweeper housing) and pulling the cover off (figure G).
• Attach the vacuum tube assembly to the fan inlet on the sweeper
housing (figure H) by lining up the tabs on the tube with the slots
on the sweeper housing and push inwards until the locking/release
button is fully engaged. (figure H1)
• Position the tube slightly above the debris/leaves. Turn the unit on,
then using a side to side sweeping motion the debris/leaves will be
sucked up the tube, mulched and deposited into the collection bag
(figure L}.
As the bag fills the power of the suction wilt decrease. To empty
collection bag, switch off your product and remove the battery from
the tool. Remove the collection bag fr,>m the power head, unzip the
collection bag to empty. Re-assemble
before continuing to operate.
When used properly on the correct
applications, this unit should not jam. This
tool isnot intendedto vacuum wet leaves
or debris and isdesigned primarily for
clean up of hard surfaces like decks, patio,_
or garages. Thetool should not be usedto
vacuum litter or non-organicdebris.
WHAT TO DO iF THE UNiT JAMS: (FIGURE M)
Z_CAUTION: TURN OFF UNiT AND REMOVE BATTERY FROM TOOL.
If the unit motor stops, the fan has become jammed. If this
happens,turn the unit off then remove the battery. Remove the bag
and vacuum tube. Remove the jamming material using a small
wooden stick. Do not use a metal implement or anything, which
may damage the fan or scratch the plastic. Ensure the fan will turn
by hand before reassembling the unit.
If the unit stops picking up debris or the performance substantially
reduces it may have become clogged. Switch the unit off then
remove the battery. Remove the vacuum tube and look down the
tube to ensure no debris is blocking it. If necessary remove debris
with a small wooden stick. Do not use a metal implement or
anything, which may scratch or
damage the tube. Remove the bag.
If the bag is full, empty the bag. If
necessary remove any debris
from around the fan or unit outlet
using a small wooden stick.
Do not use a metal implement or
anything which may damage the
fan or scratch the plastic. Ensure the
fan will turn by hand before
reassembling the unit
ACTIONS THAT MAY LEAD TO THE UNiT JAMMING ARE:
• Vacuuming wet leaves or wet debris.
• Vacuuming litter or non-organic debris.
• Vacuuming debris with an already filled bag.
• Vacuuming large twigs or sticks.
• Submerging the tip of the vacuum tube into a pile of leaves or debris.
lO