Start-Up Procedures; A) Instructions - Walter SURFOX TURBO Manual De Usuario

Start-up Procedure

A) Instructions

1. Place the unit on a flat stable surface, in a well ventilated
area where you will be working.
2. Connect ground cable to ground connector and attach
grounding clamp to work piece.
3. Connect power cable to power connector.
4. Mount the insert and cleaning pad or the brush. SURFOX
cleaning pads are made from highly heat resistant
polymers for extra long service life. The cleaning pad must
be replaced regularly.
Note: Never use the wand insert without a mounted
cleaning pad. If the pad must be replaced while working,
please observe the following:
• During the cleaning process, the wand tip and work
piece can reach very high temperatures.
Before replacing a worn cleaning pad or a brush,
switch the unit OFF and disconnect from power supply,
allow the wand tip to cool. The use of protective gloves
is recommended.
5. Pour SURFOX electrolyte solution in the container
provided
6. With switch in the OFF position, connect the unit to a
proper power supply as described under AMPERAGE.
7. Flip switch to the ON position.
8
Brush
8. Selecting the proper setting.
Select cleaning with brush when using the carbon fiber
brush. Select cleaning with pad when using the tungsten
and high conductivity pad. Always start at MIN power level.
9. Make sure the cleaning pad or brush is saturated with
SURFOX electrolyte solution before starting to work. If the
cleaning pad or brush is too dry, it will wear prematurely.
Start working when solution drips from the cleaning pad or
brush.
Do not press hard, let the electrochemical process do the
work. The cleaning pad is a bridge between the machine
and the weld. Do not use the cleaning pad like an abrasive
pad and scrub. Doing this will shorten the life of the pad.
10. When done, place wand in holder and switch unit off.
Start-up Procedure
Pad