Ecler EDRIVE 600 Manual De Instrucciones página 14

Input Channels
Gain
• Knob A: Gain, adjustable in 0.2dB steps from –80 dB to +20dB
Delay
• Knob A: Delay, adjustable in variable steps from 0 to 400ms
The delay parameter is adjustable in fine steps at low values; the
progressively coarser as the value increases. The velocity sensitive Parameter Knobs therefore provide
accurate setting of driver offset delays (typica
alignment delays.
High Pass Filter
• Knob A: Frequency, out (off), 10.0Hz to 25.6kHz in variable steps
• Knob B: high pass filter type
System high pass filtering is provided for the input signal. This is the preferred
pass filtering as it affects all outputs and can therefore improve inter-band phase relationships. Filter
type is selectable from Butterworth, Bessel, Linkwitz-Riley and Hardman. Filter slopes of up to 4th order
or 24dB / octave are provided. Not all filter types are available in all slopes. For example 18dB / octave
Linkwitz-Riley filters do not exist.
The Hardman type filter is always described
steeper rather than following a linear slope so a dB/octave description is not accurate.
14
lly below 10ms) and rapid setting of longer
by its' order as the filter becomes progressively
adjustment becomes
system
location for high