Important Remark - Ecler EDRIVE 600 Manual De Instrucciones

1. IMPORTANT REMARK

Congratulations! You are the owner of a
thank you for trusting in us and choosing our EDRIVE 600 processor.
In order to get the optimum operation and efficiency from this unit, it is VERY IMPORTANT
- before you plug anything - to read this manual ve ry carefully and bear in mind
specified within it.
We strongly recommend that its maintenance be
services.
Precautions
This apparatus must be earthed through its mains cable.
Do not expose the unit to rain or water splashes, and do not place liquid containers or
incandescent objects like candles on top of the unit.
Should any connection / disconnection task be done, always disconnect the unit from the mains
supply.
There are no user serviceable parts inside the unit.
Regulatory Compliance
This product complies with both the EMC Directive (89/336/EEC) and the Low Voltage
(73/23/EEC) as issued by the Commission of the European Community.
Compliance with these directives imply conformity with the following European standards:
• EN60065
• EN55103-1
EN55103-2
•
This product is intended for operation in the E2 (commercial & light industrial) and E3 (urban
outdoors) Electromagnetic Environments.
Ground Loops
Care should be taken, so that the different mechanical and electrical grounds,
chassis and ground connections arriving to the device, to be independent from each other.
Ground loops can be easily detected through a low frequency hum noise (50Hz). Depending
on the level of this noise, it can interfere on the music quality.
Audio connections
Usually, many people do not care enough about the quality of cables. Many times, because of a
bad connection or bad quality cables, there can be important problems during the music reproduction.
Cleaning
The control panel must not be cleaned with any
substance else paint and silk-printing could be damaged. Whenever cleaning should be necessary use a
soft cloth slightly wet with water and neutral liquid soap. Be careful that no liquid gets into
through its orifices. Never use sharp or erosive objects to scratch the control panel.
4
Product safety
Electromagnetic Interference (Emission)
Electromagnetic Susceptibility (Immunity)
carefully designed and manufactured equipment. We
carried out by our Authorised Technical
dissolvent, abrasive or petroleum derived
all considerations
Directive
as well as the
the unit