Intended Use
This instrument is intended for use in pharmacies, schools, businesses and light
industry. It must only be used for measuring the parameters described in these
operating instructions. Any other type of use and operation beyond the limits of
technical specifications, without written consent from OHAUS, is considered as not
intended. This instrument complies with current industry standards and the recognized
safety regulations; however, it can constitute a hazard in use. If the instrument is not
used according to these operating instructions, the intended protection provided by the
instrument may be impaired.
3. INSTALLATION
3.1 Select the Location
Avoid heat sources
3.2 External Connections
Battery Power Supply
3 x C (LR14) batteries can supply power to the scale. And the batteries are not included
in the packing list.
AC Power Supply
To supply power, you can connect the AC Adapter to the power receptacle, then plug
the AC Adapter into an electrical outlet.
4. OPERATION
4.1 Overview of Controls and Display
CONTROLS
CONTROL FUNCTIONS
Button
Primary Function
(Short Press)
Secondary
Function
(Press and Hold)
Rapid temperature changes
On / Zero
• Turn on the scale.
• If the scale is On, set the display to
zero.
• Perform tare operation.
Off
• If the scale is on, long press to turn
off the scale.
Air current or
excessive vibrations
• Change the weighing unit.
• Enter Dynamic Weighing or Weigh
Alert Mode.
• Initiate countdown in Dynamic
Weighing mode.
• Perform the calibration process.
EN-3
Allow sufficient space
Units
Units