Publicidad
Idiomas disponibles
Idiomas disponibles
STROBE Mode
It can work together with Auto/sound/fade/manual/0-9 modes.
Press STROBE one time for a 1/8 speed. The second time the speed will be 2/8 speed. The eighth time
it will be 100% speed.
SENSITIVITY Mode
It is a reset function. Press it one time, enter the function, press it again and the device will restore
factory setting, exiting the remote control and entering A001 mode (6 DMX channels).
SPEED Mode
No function
WIRELESS DMX CONTROL
Setup wireless DMX
The fixture needs to be paired with a wireless DMX transmitter. We advice to use MARK ® UNIVERSAL
CONTROLLER. Follow below steps to pair.
1. Connect the DMX controller to the DMX transmitter (UNIVERSAL CONTROLLER).
2. Switch on the SUPERLED BAT 144 IP WI and select "rfon" in the menu and press enter
3. Select the DMX mode (Axxx or dxxx)
4. Switch off the device. Press and hold "DMX select" button whilst switch on the fixture. The unit
passes to wireless status and the LED will be lit in white colour.
5. The colour of the LED will change according to the protocol used for the transmission as shown
on table 1. Press the button to navigate through the colours and, once the protocol has been
selected, press the button for more than 1 second in order to save the protocol. Both devices,
transmitter and fixture, will remember the protocol used in the future.
TABLE 1
COLOUR
PROTOCOL
RED
ELDMX Transmitt and receive
GREEN
W-DMX Receive
BLUE
W-DMX G3 Transmitt
YELLOW
W-DMX G4 Transmitt
PURPLE
GZ Receive (Receiver only)
10
Publicidad
