Publicidad
Idiomas disponibles
Idiomas disponibles
Using the ELDMX wireless mode
Changing channel group
Press the button to show the current channel group in use, and press it again to navigate through the
groups. The colour of the LED will indicate the group, as shown in Table 3
PROTOCO
ACTION
L
Solid colour (red, green,
blue, yellow, cyan,
magenta, white)
ELDMX/GZ
Flashing Red
Flashing Green
CAUTIONS
Prevention of electric shock
The electrical connection must only be carried out by qualified personal. Before installing, make sure
you use the same power voltage marked in the SUPERLED BAT 144 IP WI (90-240V/50-60Hz). Each
device must be properly grounded and installed in accordance with the relevant standards. Don't use
the device in a lightning storm or wet environment.
To prevent burning of fire
1. Never install the device directly on the surface of ordinary combustible material.
2. The equipment must be installed away from inflammable and explosive materials.
3. Keep at last 0,5 m around the unit to ventilation purpose.
4. Do not place any object on the lens.
5. Do not replace with non-original spare parts. Contact your MARK PRO dealer.
Unpacking
Note: Before unpacking, check it for possible damage that might have occurred during transportation
or not. If you find any damage, please do not use the unit and contact the MARK PRO dealer.
DESCRIPTION
1 of the 7 colour groups. White colour only in GZ mode
Transmitting DMX
Receiving DMX
12
Publicidad
