Publicidad
Idiomas disponibles
Idiomas disponibles
the barrier will fly away from you. Move the line head slowly until the grass is cut right up the barrier, but
do not jam(overfeed )the line into the barrier. If trimming up to a wire mesh or chain linked fence be
careful to feed only up to wire. If you go to far the line will snap off around the wire. Trimming can be
done to cut through weed stems one at a time. Place the trimmer line head near the bottom of the
weed-never high up which could cause the weed to chatter and catch the line. Rather than cut the weed
right through, just use the very end of the line to wear through the stem slowly.
CUTTING WITH A BLADE
WARNING: Do not use a brush cutter for cutting trees.
There are many different types of blades, however the two most commonly
used are the following. BRUSH BLADE is used for cutting brush and weeds
up to 3/4" in diameter. Only 10inch 3-blade can be used in this type of brush
cutter.
WARNING: Do not cut with dull, cracked or damaged metal blade.
Before cutting growth, inspect for obstructions such as boulders, metal
stakes or strands of wire from broken fences. If an obstruction cannot be
removed, mark its location so that you can avoid it with the blade. Rocks and
metal will dull or damage a blade . Wires can catch on the blade head and flap
around or be thrown into the air.
Blade thrust is the reaction which may occur when the spinning blade contacts anything it cannot cut.This
contact may cause the blade to stop for an instant ?and suddenly "thrust" the unit away from the object
that was hit.This reaction can be violent enough to cause the operator to lose control of the unit.Blade
thrust may occur without warning if the blade snags ,stalls or binds.This is more likely to occur in areas
where it is difficult to see the material being cut from cutting ease and safely,approach the weeds being
cut from the right to the left,in the event that an unexpected object or woody stock is encountered,this
could minimize the blade thrust reaction.
USING THE SHOULDER HARNESS
WARNING: Proper shoulder strap and handlebar adjustments must be made with the machine
completely stopped before using unit.
1.
Assemble and adjust the shoulder harness and belt.
2. Adjust the shoulder-harness button,and move the hook to your waist, then adjust the belt (If there
is a belt).
3. Hang the latch tab on the harness hook.
4. If the brush cutter doesn't balance,then adjust the harness hanger,and the handlebar,until the it
balances.
5. To quickly detach the brush cutter from the harness, pull the quick-release latch tab upward.
6. Insert the latch tongue in the slot of the quick-release latch to reattach the brush cutter to the harness.
18
Publicidad
