Publicidad
Idiomas disponibles
Idiomas disponibles
Section 5: Maintenance
O-Rin
Maintenance
Purchase an O-Ring/Maintenance
Kit_part number
H9H922GS
by contacting the nearest authorized service
center.Itisnot included with the pressure washer.This kit
includes rephcement
o-Mngs_ rubber washer and water
inHetfilter. Refer to the instruction sheet provided in the kit
to service your unit'sooMngs.
Pump
Maintenance
Changing Pump Oil
Change
oilevery S0 hours or once yeaMy, whichever
occurs first.
NOTE:You
must purchase a premeasured
botde of pump
oil item
number
[ 90586GS_
by
contacting
the nearest
authorized service center.
Change
pump
oil as follows:
I.
Drain engine oiland fuel from pressure washer.
2.
Use a 8ram alien wrench
to remove
bhck pump
oilcap
between
high pressure oudet and garden hose hiIet
(Figure
16).
Oil Cap
3.
Tilt pressure washer to drain oil into an approved
container until it drips slowly from pump.
4.
Tilt pressure washer in opposite direction and empty
premeasured pump oil bottle into same opening (a
small funnel may be helpful).
5.
Install black pump oil cap and tighten firmly.
6.
Set pressure washer in upright position.Add fuel and
engine oil.
ENGINE
MAINTENANCE
See the engine owner's manual for instructionson how
to
properly maintain the engine.
CAUTION
Used motor oiJ has been shown to cause skin cancer in
certain Jaboratory animaJs.
Thoroughly wash exposed areas with soap and water:
KEEP OUT
OF REACH OF CHILDREN.
DON'T
POLLUTE. CONSERVE
RESOURCES.
RETURN
USED OILTO
COLLECTION
CENTERS.
Data
Plate
Data plate information is very important ifyou need help from
our Customer Service Department or an authorized service
dealer.
, The data plate (Figure 17) is located on the base of the
pressure
washer.
For future
reference,
please copy the
model
revision,
and serial number
of the pressure
washer
in the space below.
MODEL
[
REV
NO
[
SERMAL
[
PS_
[
GPM
[
Copy Model
I Number Here
Copy Revision
]_'_
Here
_Copy
Serial
Number Here
O TR£IP BILT
Publicidad
