Troy-Bilt 020207 Manual Del Propietário página 9

Operation
HOWTO USE PRESSURE
if you have any proNems operating your pressure washen
pHeasecall the pressure washer heHpHine at 1-888-611-6788.
Pressure Washer Location
Pressure Washer Cmearance
DANGER
. Operate pressure washer ONLY outdoors,
. Keep exhaust gas fi-om entering a confined area through
windows, doors, ventilation intakes or other openings.
. DO NOT operate pressure washer inside any boning or
enclosure.
The pressure washer must be at least 5 ft. (I 52 cm) from
structures havin 8 combustible walls and/or other
combustible materials. Leave at least 3 ft. (92 cm) all around
pressure washer inchdin 8 overhea& for adequate coolin 8,
maintenance and servicin 8.
Place pressure washer
in a well ventilated
area, which
will
allow for removal of deadly exhaust gas. DO NOT place
pressure washer where exhaust gas could accumulate and
enter inside or be drawn into a potentially occupied
buiNin 8. Ensure exhaust gas is kept away from any
windows, doors, ventilation intakes or other openings that
can allow exhaust gas to collect in a confined area
(Figure 7). Prevailing winds and air currents should be taken
into consideration when positioning pressure washer.
Exhaust Port
To Start Pressure Washer
To start your pressure washer for the first time, follow these
instructions step-by4tep.This starting informatJon also applies if
you have let the pressure washer sit idle for at least a day.
I. Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
3.0 gallons per minute and no less than 20 PSI at
pressure washer end of garden hose.
2. Check that high pressure hose is tightly connected to
spray gun and pump. See "Preparin 8 Pressure Washer
For Use" for illustrations.
3. Hake sure unit is in a level position.
4. Connect garden hose to water inlet on pressure
washer pump. Turn ON water.
• Damage to equipment resuJdng from failure to follow this
instruction will void warranty.
5. Squeeze trigger on gun until you have a steady stream
of water.This purges the pump of air and impurities.
6. Attach nozzle extension to spray gun (Figure 8).
Tighten by hand.
7. Position nozzle in low pressure mode (slide nozzle
forward) and squeeze trigger on spray sun to relieve
pressure caused by turnin 8 ON water.VVater will flow
out of sun in a thin stream. Continue to hold trigger
until there is a steady stream of water and no air
remains in system. Release trigger.
8. Engage trigger lock to spray gun trigger (Figure 9).
j Trigger Lock
0