Uline H-5548 Manual De Instrucciones página 3

2
Bottom End of Locker
2
First
Locker
Figure 2
Figure 3
PAGE 3 OF 12
1
Figure 1
Interior
Sides
5
4
6
ASSEMBLY
ASSEMBLING MAIN PANELS
NOTE: Do not tighten bolts until unit is
completely assembled.
1. Place back (1) on a protected flat surface so that
the flanges face upward.
2. Bolt side (2) to back (1) so that side flange fits
around back (use 8 bolts and nuts – nuts to the
inside). Do not use bottom two holes; these will be
used for attaching legs in step 8. (See Figure 1)
3. Next, bolt top shelf (4) and bottom shelf (4) to back
and left side panel (use 4 bolts and nuts each). Bolt
shelves (5) to left side panel (use 2 bolts and nuts
each). Bolt an interior side and back panel to the
flange on the back of the first locker in ten places.
(See Figure 2)
4. Next, attach a top and bottom shelf to the first
interior side and back. Bolt shelves to the first interior
side. These will share bolts with the parts on either
side as shown in inset. (See Figure 2)
5. Next, attach another interior side and back panel
to the flange on the back of the second locker.
4
Then attach remaining shelves to the interior side.
Attach top and bottom shelf to the back.
1
(See Figure 2)
6. Bolt remaining side to the back so that side flange
fits around back. Attach side to shelves. (See Figure 3)
7. Attach coat hooks (6) to each locker's left and right
side and back panel. (See Figure 3)
NOTE: Hooks on interior sides will share bolts
and nuts with hooks in the locker next to it.
0321 IH-5548