GE 16 Serie Manual Del Propietario E Instalación página 16

Installation Instructions
El INSTALLING THE WATER LINE
(CONT.)
[] PLUG IN THE REFRIGERATOR
&_rranoe the coil of tubing so that it does not _ibrate
a
against the back of the refrigerator or against the
wall. Push the refrigerator back to the wall.
[] START THE ICEMAKER
On power switch models, set the icemaker power
switch m the I (On) position.
On feeler am_ models,
move the feeler
am_ to the ON (down)
position. The
icemaker will not begin to operate until it reaches
its operating temperature of 15°F (-9°C) or below.
It will then begin operation automatically:
Powerswitch model
Feeler A rmin
the ON(down)position
Feelerarmmodel
NOTE: In lower water pressure conditions, the
water xalxe may turn on up to 3 times to delixer
enouoh water to the icemaker.
REVERSING THE DOOR SWING
IMPORTANT NOTES
When re\'e_ing the door swing:
• Read the instructions all the way through before
starting.
• Handle parts careflflly to awfid scratching paint.
• Set screws down by their related parts to avoid using
them in the wrong places.
• Provide a non-scratching work sm'tace for
the doo_s.
IMPORTANT: Once you begin, do not move the
cabinet tmtil doo>swing reversal is completed.
These instructions are tbr changing the hinges fl'om
the right side to the leti side--if vou ever want to change
the hinges back to the right side, tk)llow these same
inst_ uctions and reverse all references to left and right.
16
TOOLS REQUIRED
Phillipsscrewdriver Maskingtape
5/16" hex-head T20or T25Torxdriver,
socketdriver (neededfor some
models)
Puttyknife or thin-blade
screwdriver
5/16" open-end
wrench