GE 16 Serie Manual Del Propietario E Instalación página 21

Installation Instructions
I_REHANGING THE DOORS
6.1 Rehang the fresh food door
6.1.1 i,ower the tresh food
door
onto the
botton_ hinge, pin. Be sure the washer
is in place on the pin.
8
Washer
Bracket
Modelswith a hingebracket
that has 2 screw holes.
Plastic
Washer
Hinge
Bracket _
Models with a hinge bracket
that has 4 screw holes.
6.1.2 Insert the pin on the center hinge into the
socket in the top of the door. Place the spacer,
then the washer, on the hinge
pin.
NOTE: The center hinge must be turned over
as shown when mounted on the left side.
Hinge Pin
and Spacer
6.1.3 Tilt the door toward the cabinet. As the door is
brought into position, slide the hinge under the
head of the screw which earlier had been partly
driven into the outermost hole. Insert the
remaining scre_, then tighten both screws
sectlrelv.
[] REHANGING THE DOORS (CONT.)
6.2 Rehang the freezer door
6.2.1 i,ower the freezer door onto the center
hiw, e_
pin.
Be sure the washer and
spacer axe in place on the pin.
CenterHinge Pin•
and Spacer
6.2.2 Tilt the door toward the cabinet, lifliw*_ the to I)
hinge so the pin fits into the socket on the top
of the door.
6.2.3. Make sure the door is slightly above the top of
the cabinet and the gap between the doors is
even across the fl'ont. Tighten the top hinge
screws. Do not overtighten these screws-tighten
them tmtil they are just snug, then tm'n them
another one-half turn.
21