GE 16 Serie Manual Del Propietario E Instalación página 19

Installation instructions
[] REVERSING THE HARDWARE
4.1 Ren/ove tile base grille (if' _our refrigerator has
one) b} pulling it straight out.
4.2 Moxe tile botton/ hinoe_ bracket (and shim glued
to it) and plastic washer from tile right side to tile
left side,
Models with a hinge bracket
that has 2 screw holes.
Modelswith a hinge bracket
that has 4 screw holes.
Switchthe hingepin to the
oppositeside of the bracket.
4.3 Interchange hinge (and the shim glued to it) and
screws at top right with screws at top left of cabinet.
Do not tighten screws on hinge side at this time,
@
Installing the hinge on the left. Installing the hinge on the right.
NOTES:
• Some hinges have fimr holes. Which holes vou
use fin" installing tile hinge depends on which
side wm install tile hinge.
• Tile outer edge of tile hinge shotfld be parallel
to tile edge of tile case for correct installation.
I
[] REVERSING THE DOOR HANDLES
5.1 Transfer fresh food door handle
5.1.1 Remove tile handle plug using a
tape-tipped putty knife under tile edge,
and rei//ove tile sci'ew tlnderneath.
Remove tile two screws holding tile
handle to tile top of tile (loot'.
Plug'_
5.1.2 Remoxe tile handle.
5.1.3 Remoxe tile screws from tile right edge of tile
door top and insert them into tile handle screw
holes on tile opposite side.
5.1.4 With tape-tipped putty knite or thin-blade
screwdriver, pry out the pltlg button from the
hinge hole on the left side of the door and
insert it into the hole on the opposite side that
was w_cated by remowd of the top hinge.
Plug Bu_
I
19