Konig & Meyer 29670 Instrucciones De Montaje página 5

29670 K&M AC 8500 SM
Information for use
Intended use
The speaker wall mount is suitable for holding a speaker with a receiving thread in the base plate
of M6. The wall mount is designed for a load capacity of 25 kg. With this mount, the emission di-
rection can be continuously adjusted horizontally and vertically. The wall mount cover conceals
the fastening elements and allows unobtrusive cable routing.
Foreseeable misapplication
Do not open the clamping and adjusting screws during use. Setting down the speaker in a jerky
manner can overload the supporting parts for a short time.
General
u It must be ensured that the speaker wall mount can be firmly connected to the wall.
u
● The wall must have sufficient load capacity and be able to absorb the resulting additional
u ●
forces.
u
● The correct fastener must be selected according to the wall condition.
u ●
e.g. bolt anchor ø 6 mm, frame dowel ø 8 mm.
u
● Pay attention to any pipes or electrical cables that may be routed.
u Observe the installation instructions for the fasteners used.
u The installer must be physically and technically fit and familiar with the currently applicable
u
local/state regulations.
u Placing the speaker on the wall mount creates a crushing hazard between them.
u The adjustment options mean there is a pinch hazard between the components.
u Due to the installation height, there is a risk of falling parts.
u The usage information is an integral part of the product and should be kept for its service life
u
or passed on to any subsequent owner or user.
Warranty
No warranty is given for damage caused by:
u Non-observance of the usage information and the "General safety and assembly instructions".
u Improper use or use for other than the intended purpose.
u Improper installation or use by the buyer or third parties.
u Natural wear and tear.
u Careless handling.
u Improper modifications or repair work by the buyer and third parties.
u Impact on components of foreign origin.
u Use of non-original spare parts.
Modifications, additions and conversions that may impair safety are prohibited without the manu-
facturer's approval.