Publicidad
Idiomas disponibles
Idiomas disponibles
8. SYSTEM'S OPERATION
Explanation of the water process when installing your equipment.
We must open the passage of water, turning the knob of the connection valve (0)
until it is in parallel with the tubing.
The water will pass through the low-pressure switch (1), which will allow the
ignition of the pressure system. The water continues through the previous filters,
first through the sediment filter (2), then through the granulated carbon filter
(3) and finally through the active carbon filter (4).
Then it continues until it reaches the pressure pump (5) (in the case of the
equipment with pump, otherwise it will pass to the next step), followed by the 4-
way valve (6), entering through the IN position and exiting through OUT, which
connects with the membrane holder (7) through the screw cap.
At the central outlet of the diaphragm holder there is a non-return valve (8),
which is connected again to the 4-way valve (6) in the IN position and at the OUT
outlet it is connected to the high pressure switch (10) and to the TE connection of
the post filter (11). This in turn is connected via the tubing to the pressurized
accumulation tank (12) at the outlet of the post filter (11).
Av. de Velázquez s/n
(Cruce Aeropuerto) 29004 Málaga
www.baezaonline.com
Atención al cliente 951 91 91 21
Publicidad
