Publicidad
Idiomas disponibles
Idiomas disponibles
Add Engine
Oil
IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended
oil may result in an engine failure.
NOTE: When adding oil to the engine crankcase, use
only high quality detergent oil rated with API service
classification SF, or SG rated SAE 10W-30 weight.
Other viscosity oils shown in the chart may be used
when the average temperature in your area is within
the recommended
range.
-20
0
20
40
60
80
100°F
I
I
!
I
I
I
I
I
-30 -20
-10
0
10
20
30
40°C
AMBIENT TEMPERATURE
•
Place pressure washer on a level surface.
•
Clean area around oil fill, remove oil dipstick and
wipe it clean.
•
Insert and remove the dipstick without screwing it
into the filler neck.
OIL FILLER CAP/DIPSTICK
I LIMIT
Add Gasoline
A
ANGER!
Never fill fuel tank indoors. Never fill
fuel tank when engine is running or hot. Do Not
smoke when filling fuel tank.
A
ARNING!
Never fill fuel tank completely full.
Provide space for fuel expansion. Wipe away
any fuel spillage from engine and equipment
before starting.
Use fresh, clean unleaded automotive gasoline.
•
Use clean fuel and store in approved, clean,
covered containers. Use clean fill funnels. Never
use "stale" gasoline left over from last season or
gasoline stored for long periods.
•
Clean area around fuel fill cap, remove cap.
•
Slowly add gasoline to fuel tank. Use a funnel to
prevent spillage. Fill tank to "Fuel Level Mark" as
shown below.
___
MAXIMUM
FUEL LEVEL
-
-_FUEL
LEVEL
- _-.
_
MARK
•
Install fuel cap and wipe up any spilled gasoline.
•
Slowly pour oil into oil fill opening until oil reaches
"UPPER LIMIT" mark on the dipstick. Stop
occasionally to check oil level.
•
If the oil level is near or below the lower limit mark
on the dipstick, fill with the recommended oil to the
upper limit mark. DO NOT OVERFILL.
•
Install oil dipstick, hand tighten securely.
NOTE: Check oil often during engine break-in.
Publicidad
