Publicidad
Idiomas disponibles
Idiomas disponibles
MANUFACTURER
mode
Spot welds programmed by the user can be recalled by selecting USER in the manufacturers list. Welding spots can be programmed using the GYSPOT
software and the welding spots settings module.
Push the button
for 2 seconds to return to the AUTO mode.
ENERGY mode
To enable this mode, first perform a weld without a load. Push the button
screen. Push the button again to calibrate. Once the calibration has been done, the machine displays the last values used in this mode for current
and energy. The use can then modify the welding current, energy and resistance. The duration of the weld will vary based on the time required for
the machine to reach the energy level required. If it is taking too long, the machine will display the error message «maximum duration reached».
Push the button
for 2 seconds to return to the AUTO mode.
SETTINGS MENU
GYSPOT PTI S7
The MANUFACTURER mode is optional; it can be modified using the « Settings» menu.
This mode is used to name a pre-registered spot based on the repair book issued by the manufacturer.
The ENERGY mode is optional and can be set using the «Settings» menu.
This mode is used to control the energy transmitted during the weld. This mode is not designed to be used
during repairs but for the benefit of manufacturers and quality control organisations conducting tests.
This menu is accessible by pressing and holding the button
The language used in the menu can amended on line 1.
The date and the time can be programmed on line 2.
The modes GYSTEEL, MANUFACTURER , AUTO, ENERGY, NORMAL et MULTISHEETS can be activated or deacti-
vated using this menu.
Ce menu est accessible en pressant la touche
La langue des menus peut être sélectionnée en ligne 1.
La date et l'heure peuvent être programmées en ligne 2.
Les modes GYSTEEL, CONSTRUCTEUR, AUTO, ENERGY, NORMAL et MULTITOLES peuvent être activés / désac-
tivés dans ce menu.
daN control :
This setting allows you to activate or control the clamping force of the clamp during a weld.
(FIG 2
-9). The message «Do a spot without a load» is displayed on the
for 2 seconds.
pendant plus de 2 secondes.
EN
41
Publicidad
