ANSMANN 1700-0174 Manual De Operación página 8

Powerstation near the car battery, ensuring a secure position.
• Connect the red clamp to the positive pole (+) of the car battery. Connect the black
clamp to the negative pole (-) of the car battery.
• The following operating modes are now possible:
- Green light is on continuously: The connection has been established correctly.
- Green light is blinking: The car battery is very deeply discharged. Press the "BOOST"
button on the Jumpstart cable and wait until the green light shines continuously. Start
the engine within the next 30 seconds.
- Red light is on, audible warning signal: The connection clamps are incorrectly atta-
ched. Remove the connection clamps and reconnect as described in point 2.
- No light is on, no audible signal: The car battery may be damaged and non-functio-
nal. If you are certain that the connection clamps are attached correctly, you can try
to activate the battery using the "BOOST" mode.
• You can now start the vehicle directly.
• Once the engine is running, remove the connection clamps and disconnect the Power-
station from the vehicle.
⚠ ATTENTION!
• Never press the "BOOST" button before the connection clamps are properly attached
to the car battery.
• Never short-circuit or connect the connection clamps together.
• Use exclusively with 12V car batteries.
circle-c ENVIRONMENTAL INFORMATION | DISPOSAL
Dispose of packaging after sorting by material type. Cardboard and cardboard to the
waste paper, film to the recycling collection.
Dispose of the unusable product in accordance with legal provisions. The "waste
bin" symbol indicates that, in the EU, it is not permitted to dispose of electrical
equipment in household waste.
For disposal, pass the product on to a specialist disposal point for old equipment, use
the return and collection systems in your area or contact the dealer from whom you
purchased the product.
circle-c LIABILITY DISCLAIMER
The information contained within these operating instructions can be changed without
prior notification. We accept no liability for direct, indirect, incidental or other damage
or consequential damage arising though improper handling/use or through disregard of
the information contained within these operating instructions.
- The product complies with the requirements from the EU directives.
Subject to technical changes. We assume no liability for printing errors.
8