fadini Bart 350 Instrucciones página 2

GENERAL INFORMATION REGARDING ELPRO 35M
ELECTRICAL CONNECTIONS
Accessory
Connections for 2
Bart 350 swinging
gate operators
Master Slave
n°3 x 1,5
n°4 x 0,5
Elpro 35M
on Bart 350
Master
LINK
Connections for 1
NOTE WELL: when Bart 350 Master is to be mounted
Bart 350 swinging
onto a single swinging gate bridge A-C and B-D.
gate operator
Master
to the TERMINALS
Electrical connections
ATTENTION: the only electrical connections 3x1,5 and 4x0,5
between the two boards allow the Elpro 35 M programmer
to dialogue with the second Slave gate during programming
and operation.
All the accessories for command, signalling and safety must
be connected to the terminals of the Elpro 35M that manages
and controls the entire system.
Elpro 35M
on Bart 350
Master
LINK
and ELPRO 35S
and THEIR FUNCTIONS
Motor 24V
Bart Slave
Motor
microprocessor
LED lamp
- 30 -
Instructions
Dip-switches and LED indication
of their functions
Refer to the previous pages for the
Dip-Switch arrangements relative to the
individual accessories and functions
The GREEN LEDs, in particular the LINK LED
on Elpro 35M, must be on: this con rms
proper communication between the Bart
Master and Slave on respective terminals
A-B-C-D
Bart Slave
FCA
release lever = Bart Slave opening
switch limit switch LED
FCC
= Bart Slave closing
limit switch LED
Elpro 35S
on Bart 350
Slave
For installation and
adjustment of limit switch
microswitches, see pg. 11
Refer to the previous pages for the
Dip-Switch arrangements relative to the
individual accessories and functions
The GREEN LEDs, in particular the LINK LED
on Elpro 35M, must be on: this con rms that
terminals A-C and B-D are correctly bridged
Bart Slave
limit switch
connector