Garland ASH 120 E Manual De Instrucciones página 27

6.3. START-UP
6.3.1. VERIFICATION POINTS BEFORE
COMMISSIONING START-UP
The voltage and current supply must comply with the
indications on the rating plate.
Before starting work, make sure that the appliance
operates correctly and that its operation is safe.
Do not use machine is if it is damaged or incorrectly
regulated.
Use this machine for the purpose for which it was
designed. Any other use may be dangerous for the
user, for the machine and for persons, animals and
things in its surroundings.
Check that the electrical outlet and extension cord are
undamaged and that they fulfill the requirements for
this machine.
Tighten, repair or replace everything needed before
using the machine.
Do not use any accessory on this machine outside of
those recommended by us since its use could cause
damage to the user, machine, and people, animals
and things close to the machine.
6.3.2. TURNING ON AND OFF
Turning on the machine:
Place the switch in the "I" (ON) position.
Turning off the machine:
Place the switch in the "0" (OFF) position.
Do not start and stop the machine again and again
within a few seconds, or submit to the engine to an
important job, this will generate too much heat and
will decrease the life of your engine. We recommend
that whenever you stop the machine wait at least 5
seconds before turning it on.
6.3.3. VERIFICATION POINTS AFTER TURNING ON
It is important to pay attention to the possible
individual parts or the temperature of the machine.
If you detect any abnormality in the machine
immediately stop and check it carefully. In case of any
malfunction or problem take the machine for service
to be repaired. Under no circumstance should you
continue working if you notice that the machine is not
working correctly.
Do not use the machine if it is damaged or improperly
adjusted.
Caution – Keep filters clean. Efficiency of the
vacuum is largely dependent on the filter. A clogged
filter can cause overheating and possibly damagethe
cleaner. Check the filter periodically and replace as
required.
7. USING THE MACHINE
Do not pick up ash; such as wood or coal ash;
without cartridge filter in place. These are very fine
particles that may pass through the wire screen and
affect the performance of the motor or be exhausted
back into the air.
1. The cleaner is for dry pick up only, do not vacuum
wet ashes. Wait until the oven and ashes have
completely cooled down before using your cleaner.
Ashes that appear to have cooled down may still be
hot inside and could reignite with airflow. Temperature
exceeding 100° F (40° C) may damage the cleaner.
27/100
English