Garland ASH 120 E Manual De Instrucciones página 28

English
2. Turn the unit on and use the metal intake nozzle
or metal crevice tool (not standard with all models) to
vacuum up the debris. Never use the cleaner without the
intake nozzle or crevice tool in place. NOTE: To prevent the
unit from tipping over, do not pull on the hose.
3. After you have finished the cleaning job, run the
unit for 30 seconds to ensure all debris has been
deposited in the tank.
4. Empty and clean the tank. If there is any debris on
the wire screen, located on the tank cover, carefully
brush it off. Clean the cartridge filter following the
instructions under the Installing the Cartridge Filter
section in this manual.
To avoid spontaneous combustion, empty tank
after each use.
¡WARNING! If the cleaner has been used to pick
up any debris other than ashes; the tank, tank cover,
wire screen, cartridge filter and motor housing must
be completely cleaned before using it to pick up
ashes. picking up ashes in a unit containing other
debris could result in a fire should an ash reignite and
touch flmable debris.
NOTICE!: Automatic adjustment thermal protection
device.
This feature protects the unit by shutting off the
cleaner should a pre-set temperature be exceeded.
This condition typically occurs due to hot debris being
present in the tank.
1. Turn the cleaner OFF and disconnect the plug from
the outlet.
2. Move the cleaner to a safe area outside, remove
the motor from the tank and allow to cool down under
close supervision.
3. Check for a clogged, dirty cartridge filter. Clean or
replace filter, if needed.
4. Check for a clogged, dirty wire screen. Carefully,
brush off debris.
5. Check hose for blockage. Remove any obstruction
found in hose.
6. The Thermal Protective Device will automatically
reset in approximately 10 minutes.
7. Wait until the ashes have completely cooled down.
Turn the cleaner ON and continue cleaning.
¡WARNING! If the cleaner has been used to pick
up any debris other than ashes; the tank, tank cover,
wire screen, cartridge filter and motor housing must
be completely cleaned before using it to pick up
ashes. picking up ashes in a unit containing other
debris could result in a fire should an ash reignite and
touch flmable debris.
8. MAINTENANCE AND SERVICE
Unplug the machine before completing any
operation on the machine. Read the instruction
manual before doing any operation with the machine.
Do not ever attempt to do adjustments on the
machine if it is running. Perform all maintenance
of the machine while it is placed on a flat, cleared
surface.
Always perform the maintenance or service with the
power to the machine unplugged.
Keep the machine clean, especially the motor vent
windows.
28/100