Publicidad
Idiomas disponibles
Idiomas disponibles
ToolsNeeded:
* Standard # 2 Phillips screwdriver
o Tape-tippedputtyknife
* Needle-nosedpliers
1 Open
the door and remove
the
filler plugs opposite
the hinges.
2 With the door
completely
open,
remove
the bottom
screw from
each hinge
on the dryer face.
Rotate
the door
180 ° . Insert
it
on the opposite
side of the open-
ing by moving
the door IN and
DOWN
until the top hinge
and
the bottom
hinge
are resting
on
the top screws inserted
in step 3.
3 Insert these screws about halfway
into the TOP holes, fk_reach hinge,
on the opposite side (where you
removed the filler plugs). Apply
firm pressure to get the screw
started in untapped holes.
4 Loosen the top screw from each
hinge on the dryer face halfway.
7 Remove
the remaining
screws
from the side of the opening
from which the door was
removed.
With these screws
secure each hinge at the bottom.
I
Li r
12
5 With one hand holding the top
of the door and the other hand
holding the bottom, remove the
door from the dryer by lifting it
UP and OUT.
8 Tighten
the two top screws of
each hinge.
9 Reinsert
the plastic
plugs
on
the side from which
the door
was removed.
Publicidad
