GE DPSQ495ET Manual Del Propietário página 17

%
Problem Possible Causes What to Do
Overdrying ° TI T a fabric softener.
• Adjust conuols for less drying.
No fabric softener was used • TI T a fabric softener.
Synthetics, permanent press ° TI T a fabric softener.
and blends can cause static
Improper sorting Separate heavy items from lightweight items
(generally, a well-sorted washer load is a
well-sorted dryer load).
Large loads of heavy items • Large, heavy loads contain more moisture
(like beach towels) and take longer to dI y. Separate large, heavy
items into smaller loads to speed drying time.
Controls improperly set • Match control settings to the load you
are duing.
Lint filter is full • Clean lint filter before every load.
Improper or obstructed • Check installation instructions for proper
ducting ducting/venting.
Blown fuses or tripped
circuit breakers
Overloading/
combining loads
Underloading
Make sure ducting is clean, flee of kinks
and unobstructed.
Check to see if outside wall damper
operates easily.
See the Venting the DiTer section.
Replace fuses or reset circuit breakers. Since
most &Ters use 2 fuses/breakers, make sure
both are operating.
Do not put more than one washer load in
the dryer at a time.
If you are diTing only one or two items,
add a few items to ensure proper tumbling.
18