Vitrifrigo SLIM Serie Manual De Instrucciones página 24

Door latch inversion
Remove the door latch and the cover from the door. To remove the handle, unscrew it.
Reassemble them on the opposite side.
The procedure indicates the left-right inversion. Make the steps opposite to the
right-left opening.
7. DOOR PANEL REPLACEMENT
Is possible replace the fridge and drawer door panels by following the instructions below.
(Annex 6)
• Remove the plastic base using a screwdriver
• Remove one or both panels and replace them
• To facilitate replacement, remove the door
The panel can also be replaced with one of a different thickness. The thickness can vary
from 0.8 to 3 mm.
8. ELECTRICAL CONNECTION
This installation and electrical connection must perform in accordance with the
regulations by a qualified technician. Connect the DC power supply to 12V or 24V
directly to the battery according to the following instructions.
Section (mm^2)
2.5
4
6
10
• Cable size: Battery and electronics connection.
12 V cut-out V
10,4
Protect the DC power line with a suitable min. 20A circuit breaker. Provide a fuse close to
the positive battery pole and a 15A fuse for 12 VDC power supply and 7.5A for 24 VDC
power supply.
ENG
24
RESPECT THE POLARITY
Max line length 12V (m)
STANDARD BATTERY PROTECTION SETTINGS
12 V cut-in V
11,7
2.5
4
6
10
24 V cut-out V
22,8
Max line length 24V (m)
5
8
12
20
24 V cut-in V
24,2