MTD 450 Serie Manual Del Operador página 8

Setting u p
MPORTANT
This unitis shipped
without gasoline or
oil in the enginelae
certain to serv ce
engine with gasoline
an_Joil as instructed
in the separate engine
manUaI beforeope!at-
ing your machine
NOTE: All references
in this manual tOthe
left or right side of
the chipper shredder
iSfrom the operating
position onlyl Excep;
tions, if any, w Ii be
specified:
i
NOTE: This Operators
ManUalcovers a range
Of product specifiCa:
tions for Various
mode!s:Characteristics
and featuresdiscussed
andior ilUstratedinthiS
manual may not be ap,
plicable toali models!
MTD LLC reservesthe
right to change product
specificationsidesigns
andequipment w thout
notice and without
incurring obligationl
Figure 3-7
/
/
/
/
ji
//
// ///
//
/
7. Thechippershredderwas shippedwith one end of
the supportbracealreadysecuredto the lowerframe.
Loosenbut do not removethebolts securingthe brace
to the frame.See Figure3-7.
a. Align the holesin the chutewith the holes in the top
of the braceand attachbraceto chipperchute with
hardwarepreviouslyremoved.Tightensecurely.
b. Tightenthe bolts securingthe supportbraceto the
frame.
c. Tightenthe three nutson the weldstudsholding
the chipperchuteto the impellerhousing.
Attaching The Chipper Chute
(Model Series 450)
8. a. Removethethreecuppedwashersand hex nuts
fromweld studsaroundtheopeningon the sideof
the impellerhousing.See Figure3-8.
Figure 3=8
8