Descargar Imprimir esta página

Axxess GMOS-100 Instrucciones De Instalación página 18

Publicidad

Idiomas disponibles

Idiomas disponibles

Connections to be made
2. From the 22-way harness:
Connect the 3.5mm jack to the aftermarket radio's steering wheel control (SWC) input
(if equipped). Note: If using Eclipse, Kenwood, or select JVC radios use the supplied
female 3.5mm adaptor.
• For Kenwood and select JVC radios: Connect the SWC wire (normally Blue/
Yellow) to the Brown wire of the ASWC. Isolate and tape the Brown/White wire,
it will not be used.
Some of the newer Kenwood radios will auto detect as a JVC. If this is the case, you
can use a 12k ohm resistor (included) in line between the Blue/Yellow and Brown
wire of the female 3.5mm jack during programming only. Or you can manually set
the radio type which is in the radio programming section of this manual.
• For Eclipse radios: Connect the Eclipse SWC wires (Normally Brown and Brown/
Black) to the Brown and Brown/White wires of the ASWC. Brown goes to Brown
and Brown/White goes to Brown/Black. Sometimes this is reversed, so reverse the
wires if needed.
• For Metra OE radios: Connect the SWC Key 1 wire (Gray) to the Brown wire of the
ASWC female 3.5 adapter.
• For all other radios, plug in the male 3.5mm connector of the ASWC into the
back of the aftermarket radio, designated for an external SWC control interface.
Please refer to the aftermarket radios manual if you are in doubt where the 3.5mm
connector of the ASWC goes.
• The Black/Yellow wire will be discussed later on in the instructions.
3. From the 24-way harness:
• Connect the Black wire to the ground wire of the aftermarket radio.
• Connect the Yellow wire to the constant wire of the aftermarket radio.
• If the vehicle is amplified disconnect the 4-pin harness located between the 30-way
and 22-way connector and connect the supplied 4-pin to 4-pin resistor pad. If the
vehicle is not amplified connect the two 4-pins for the 30 and 22-way together.
For amplified systems:
• Connect the Violet wire to the right rear positive wire of the aftermarket radio.
Continue on next page
Section 3: Class II
3.2

Publicidad

loading