Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
Avoid accidental starting. Make sure you are
in the starting position when pulling the starter rope (Fig. 6).
To avoid serious injury, the operator and unit must be
in a stable position while starting.
ThrotUe Control
Start/On
(I)
On/Off Control
STARTING iNSTRUCTiONS
1. Mix gasoline with oil. Refer to Oil and Fuel Mixing Instructions.
2. Fill the fuel tank. Refer to Fueling the Unit.
NOTE: There is no need to turn the unit on. The On/Off Control is in
the ON ( I ) position at all times (Fig. 4).
3. Fully press and release the primer bulb 10 times, slowly. Some
amount of fuel should be visible in the primer bulb (Fig. 5). If fuel
can not be seen in the bulb, press and release the bulb until fuel
is visible.
4. Move the choke lever to Position
1 (Fig. 5).
5. Stand in the starting position (Fig. 6). Hold the handlebar and
squeeze the throttle contol with one hand. Hold the starter rope
with the other hand. Use one foot to hold the wheels in place.
NOTE: Always tilt the unit back slightly to bring the tines off the
ground when starting the unit (Fig. 6).
6. SQUEEZE and HOLD the throttle control for ALL further steps.
Pull the starter rope 5 times.
7. Continue
to squeeze the throttle
control.
Move the choke
lever to Position 2 (Fig. 5).
8. Continue
to squeeze the throttle
control.
Pull the starter rope
3-5 times to start the engine.
9. Continue
to squeeze the throttle
control.
Allow the engine to
warm up for 30-60 seconds.
10. Continue
to squeeze the throttle
control.
Move the choke
lever to Position 3 (Fig. 5).
11. Continue
to squeeze the throttle
control.
Run the unit for an
additional 60 seconds to complete the warm-up. The unit may
be used during this step.
NOTE: The unit is properly warmed up when the engine accelerates
without hesitation.
IF... The engine hesitates, return the choke lever to Position 2 and
continue the warm-up.
IF... The engine does not start, go back to step 3.
IF... The engine fails to start after 2 attempts, move the choke lever
to Position 3 and squeeze the throttle control. Pull the starter
rope 3=8 times in a controlled and steady motion. The engine
should start. If not, repeat.
IF WARM... If the engine is already warm, go back to step 7.
Position
Position 2
Position 3
Starting Position
Starter
Rope
Stop/Off
(O)
Fig. 4
Fig. 5
Bulb
Throttle
Control
Fig. 6
STOPPING
iNSTRUCTiONS
1. Release the throttle control. Allow the engine to cool down by idling.
2. Press and hold the On/Off Control in the OFF (O) position until
the unit comes to a complete stop (Fig. 4).
Publicidad
