Descargar Imprimir esta página

Fulgor Milano FWD 3024 Instrucciones Para La Instalación Y Uso página 24

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 55
Replacing an Drawer Light
• Each warming drawer is equipped with three halogen
lights located in the lateral walls.
• Each light assembly consists of a removable lens, a light
bulb as well as a light socket housing that is fixed in
GB
place. See figure on this page.
• Light bulb replacement is considered to be a routine
maintenance item.
To Replace a Light Bulb
1. Read WARNING on this page.
2. Turn off power at the main power supply (fuse or
breaker box).
3. Remove the lens between screw and glass using a
screw driver.
4. Remove the light bulb from its socket by pulling it.
5. Replace the bulb with a new one. Avoid touching the
bulb with fingers, as oils from hands can damage the
bulb when it becomes hot.
6. The bulb is halogen: use one with the same type
checking Voltage and Wattage.
7. Place the lens back on.
Turn power back on at the main power supply (fuse or
breaker box).
• Make sure the lights are cool and power to the
drawer has been turned off before replacing the
light bulb(s). Failure to do so could result in electrical
shock or burns.
• The lenses must be in place when using the drawer.
• The lenses serve to protect the light bulb from
breaking.
• The lenses are made of glass. Handle carefully to
avoid breakage. Broken glass could cause an injury.
WARNING
24

Publicidad

loading

Este manual también es adecuado para:

Fpdw 3020