Danby DCR412W Manual Del Propietário página 2

ATTENTION
GROUNDING INSTRUCTIONS
This appliance must be grounded In
the event of an electrical short circuit;
grounding reduces the risk of etectrlcal
shock by provldtng &n escape wire for the
electrical current° This appliance is
equipped with a cord having a grounding
wire with a grounding plug The plug must
be plugged into an outlet that is properly
installed and grounded.
WARNING - Improper use of the
grounding plug can result in a risk of electric
shock. Consult a qualified electrician or
serviceman if the grounding lnstruclions are
not completely understood, or if the doubt
exists as to whether the appliance is
properly grounded.
DO NOT USE AN EXTENSION CORD
Usean exclusivewall oulleL Do not connect
yo'_rrefrigerator to extension.cords or
togetherwith any otherapp!tance in the
samewall outlet. Do notsplice the cord,
IMPORTANT WARNING
An empty refrigerator is a Very dangerous
attraction to chi}dren, Remove either the
gasket, latches, lids or doors from unused
appliances, or take some other action that
witlguarantee it harmless°
DANGER; R iskofchild enltapment Beforeyou1brow away
youroldrefrigeratororfreezer:
• Takeoffthedoors
• LeaVe _e shelves inplacesothat chltdmn m ay
noteasily oitrnbInsider
DON'T WAITI DO IT NOWI
Location
1. Select a place with a strong, level floor,
2. Allow 5 inches of space between the back of
the refrigerator and any adjacent wail
3. Avoid direct sunlight and heal Direct
sunlight may affect the acrylic coating.
Heat sources nearby will cause higher
electricity consumption°
4_ Avoid very moist places. Too much moisture
In the air will cause frost to form very quickly
on the evaporato_', and your refrigerator will
have to be defrosted very frequenUy.
To avoid vibr,_tion, the cabinet must be set level.
To start the refrigerator, turn the temperature
control to the position corresponding to the
desired cooling, The refrigerator temperature
wlli vary depending on the quantity of the food
stored and on the frequency with which the door
is opened°
Turn the control to the "O" position to
temporarily disconnect the cooling cycle. After
defrostitlg and if the refrigerator has been left out
of use for some time,,set the control to maxtmum
for ;2to 3 hours before turning to the desired
position_ When the refrigerator is not to be used
for a long period of time, disconnect the plug and
leav e the door partia!ly open.
Note: Wait 3 to 5 minutes before restarting if
operation has been interrupted,
tceCubes
Ice cube tray is flexible, Twist tray to remove ice
cubes. If the Ice cube tray is frozen hard Io the
evaporator surface, run a little water over the tray.
Never use a knife or other metal instrument to
remove ice cube tray because this may damage
the evaporator. (Fig. C)
Remove the exterior and interior packings, wipe
the outside thoroughly with a soft dry cloth and
the inside wtth a wet, lukewarm cloth. Avoid
placing the cabinet in a narrow recess or near
any heat source, direct sunlight, or moisture°
Lel air circulate freely around the cabinet. Keep
the rear of the refrigerator 5 inches away from
the walt.
Fig. C