Indel Webasto Marine ISOTHERM Digital Display Manual De Instrucciones página 31

ISOTHERM Digital Display
COMPATIBILITY
- The device is compatible only with control units code IWM SEG00002DA Secop
version 101N0212 and SEG00030GA Secop version 101N0510.
Make sure that your device is equipped with this specific control unit before
installation.
Instruction and Use
This manual contains warnings to signal dangers to the user or particular behaviour
to comply with; these warnings are indicated as follows:
WARNING!
manual.
Obligation to read instructions
The presence of this symbol mandates reading of instructions before
putting the unit into operation.
Obligation to disconnect
The presence of this symbol mandates immediate disconnection of the
unit from the mains in case of failures.
Obligation to wear gloves
The presence of this symbol mandates each operator wear suitable
protective gloves.
Obligation to wear shoes
The presence of this symbol mandates each operator wear shoes de-
signed to decrease the risk of injury.
General hazard
The presence of this symbol mandates special attention by the opera-
tor.
Do not start the product before reading this instruction
31