Indel Webasto Marine ISOTHERM Digital Display Manual De Instrucciones página 41

ISOTHERM Digital Display
- Possibility of selecting and checking the temperature within a wide-scale
range from that of the refrigerator and that of the freezer
- Possibility of selecting temperature indication in Celsius or Fahrenheit
- Possibility of operation with the maximum level of performance or energy
saving
- Possibility of selecting 3 different battery protection levels and resulting
compressor operation
- Possibility of setting temperature offset for 3 different temperature ranges
- Possibility of sub-cooling in the event of an available surplus of energy
- Description of the functions of buttons present on the Display Fig.27:
o Direct functions
•
•
•
•
•
•
•
o Description:
•
•
•
•
1 On button
2 ECO / ITC function change button
3 Display
4 ITC active function LED
5 ECO active function LED
6 Button for temperature value decrease or menu scrolling
7 Button for temperature value increase or menu scrolling
«1» Unit On and Off button. To switch on the refrigerator, press
button «1». The compressor will switch ON with factory pre-set
settings. The temperature shown on the display is in degrees
centigrade and corresponds with room temperature when starting
up for the first time.
«2» Press button 2 to activate the ECO or ITC mode, alternatively.
When one of the two functions is active, the corresponding LED
under the display will light up.
With ECO function active, the refrigerator will operate at
minimum power, in energy-savings mode. Achievement of the set
temperature cannot be guaranteed in this mode.
With the ITC function active, FAST COOLING activates, or rather
41