Indel Webasto Marine ISOTHERM Digital Display Manual De Instrucciones página 35

ISOTHERM Digital Display
INTRODUCTION
- The Digital Display is able to clearly and simply display, control and regulate
temperature within a refrigerated compartment from the outside. By means
of an electronic sensor, the electronic control unit detects the actual air
temperature, supply voltage and any errors inside the refrigerator. Software
processes the data, combining them with the user selected settings directly
on the display, and defines compressor operation.
The system is equipped with:
- Soft Start (always present) for effective, safe start-up of the compressor
- Fast Cooling (in ITC mode) to lower the temperature as quickly as
possible
- Over Cooling (to be set) to accumulate cold when there is a surplus of
energy, for example with the motor on, to use it when power is only
coming from the battery
- Components making up the kit:
o Instructions manual
o Digital display
o Digital display support frame
o Container for wall installation
o Container for flush mounting installation
o Temperature sensor with cable
o Grille and temperature sensor support
o Display connection cable
o 2 M2.5 screws
o 2 self-tapping screws
o Rubber cable gland
35