Roborock Dyad Pro Combo Manual Del Usuario página 9

expose the crevice tool head. The cleaning
head is switched to a crevice tool.
Notes:
• Do not use any cleaning head for floor drying.
• Do not touch the rotating part of the cleaning head.
Routine Maintenance
E
To maintain optimal performance of the
product, refer to the following table for routine
maintenance.
Maintenance
Parts
Frequency
Roller 2–4 weeks
Filter (dirty tank) 1 month
Filter (dustbin) 1 month
Cleaning head
and dirty water 1 month
pipe
Dirty tank 1 month
Dirty water level
1 month
sensor
Charging dock
As needed
tray
Charging
1 month
contacts
Dustbin 1 month
Multi-Surface
1 month
Brush
Motorized
1 month
Mini-Brush
Product Maintenance
If this product is left unused for a prolonged
period of time, fully charge it and unplug it
before storing it in a cool and dry place. Do not
place the product in humid locations or under
direct sunlight. Charge it at least once every 3
months to avoid overdischarge.
Cleaning the Main Unit and Body
Wipe and clean the main unit and the body
with a soft and dry cloth. Before cleaning,
unplug the power supply and power the
Replacement
cleaner off.
Frequency
Cleaning the Dirty Tank
6–12 months E1
and Filter
6–12 months
E1-1— Take out the dirty tank, pull out the
6–12 months
cover, and open the water level sensors.
Clean the parts with the provided
N/A
maintenance brush, rinse them with
cold water, and then snap the water
N/A
level sensors back in place.
N/A
E1-2—
Take out the filter from the dirty water
tank cover and remove any trash
N/A
attached to the filter. If the filter is dirty,
rinse it with cold water and then shake
N/A
off the residual water.
E1-3— Allow up to 24 hours for all parts drying
N/A
and install them back in place.
N/A
Notes:
• Use a second filter if necessary.
• Do not touch the filter with your hands, brushes, or sharp
N/A
objects to avoid damage to the filter.
Cleaning the Rollers
E2
1. Remove the vacuum cleaner from the
E2-1—
E2-2—
E2-3—
Note:
E2-4—
E2-5—
E2-6—
E3
and Dirty Water Pipe
1. Remove the dirty tank and front and rear
2. Clean the roller slots and dirty water pipe
3. Wipe the charging contacts with a dry cloth.
4. Reinstall the rollers and dirty tank in place.
E3-1— Charging Contacts
Note: Do not rinse the cleaning head directly with water.
08
charging dock, and switch it off. Stabilize
the body.
Rotate the rear roller cover to the
unlock position, and pull the rear roller
outward.
Pinch the left and right front rollers with
both hands, and pull them outward.
Cut off any hair entangled on the
rollers and remove any debris using the
provided maintenance brush.
Use the maintenance brush carefully to avoid injury.
Insert the rear roller from the side, and
then rotate the rear roller cover from
the unlock position to the lock position
until it clicks in place.
Note: Do not rinse the cleaning head
directly with water.
To install the front rollers, marked red
and blue, on the correct sides of the
head. Pinch them with both hands and
align them with the front roller shaft.
Push inward to install properly.
Cleaning the Cleaning Head
rollers. Switch off the vacuum cleaner and
stabilize the body.
with the maintenance brush provided.