Programming User Options - Raytheon Amana Menumaster MM2000C Serie Manual Del Propietário

ENUMASTER
J
ETWAVE III

Programming User Options

User options change oven features to meet
specific needs. See table below for options.
Setting User Options
1.Verify Oven shows "READY" in display.
• If oven display shows "STANDBY",
press ON/STANDBY pad.
• If "R" in "READY" is not flashing, open
and close oven door.
• Preheat temperature and "PREHEAT"
appear in display if oven is in preheat
mode.
2. Open oven door. Oven door must remain
open during programming.
3. Press and hold 1 pad for approximately
3–5 seconds.
SELECT MENU AND PAD
A PAD ?
Current Menu
Number Display Titles
Pads
1 MANUAL
PROGRAMMING
2 SLEW RATE
3 TEMP SCALE
DEGREES
4 DEFAULT COOK
TIME
5 SPEAKER
VOLUME
6 KEYBEEPS
7 END OF CYCLE
TONE
8 MAGNETRON
HOURS
DOOR CYCLES
HIDDEN
ON
ENABLE
STANDBY
PAD
4. Press hidden enable pad located left of
5. Press (1–8) pads to review options. See
6. Press arrow pads to select option.
7. Press START pad to enter option.
8. Close door to exit user options
Options
( ) = Factory Setting
(ENABLE) or DISABLE
SLOW, MEDIUM,
(MEDIUM-FAST), or FAST
(F) or C
(2:00) 00:00-10:00
LOW, MEDIUM, (HIGH), or
OFF
(ON) or OFF
(CONTINUOUS TONE),
CONTINUOUS BEEP,
4 CYCLES OF BEEP,
or 3 SECOND TONE
MAGNETRON HOURS and
DOOR CYCLES
MICROWAVE CONVECTION COMBINATION
MENU
PRE-
A B C
HEAT
ON/STANDBY pad.
USER OPTIONS: PRESS
DIGIT PADS TO REVIEW
table below for descriptions.
programming mode.
Summary of Setting User Options
1. Open oven door.
2. Press and hold 1 pad.
3. Press hidden enable pad.
4. Press (1–8) pads.
5. Press arrow pads.
6. Press START pad to save.
7. Close door to exit.
Description
Allows or prevents manual programming of oven.
Controls speed of arrow pads.
Displays temperatures in Fahrenheit or Celsius.
When oven converts preprogrammed and default
temperatures from Fahrenheit to Celsius,
temperatures set to the next lowest factor of 10
degrees Celsius. From Celsius to Fahrenheit,
temperatures set to the next lowest factor of 25
degrees Fahrenheit.
Sets default cooking time.
Controls oven signal volume.
Controls whether pads signal when pressed.
Determines how oven signals at end of cycle.
Displays how many hours magnetron tube has
operated and how many times door has opened
and shut.
17
OPTION
START
1
2
3
4
5
6
7
8
STOP
RESET