Publicidad
Idiomas disponibles
Idiomas disponibles
• Screw the mounting bracket with the supplied screws to a wall, a fence, a tree or any
similar place.
• After mounting, the device will easily slip into the bracket.
W arning! Before drilling, make sure there
are no gas, water or power lines at the drill-
ing site. Installation only by competent
persons. It is very important to pay atten-
tion to the condition of the wall, as the en-
closed fixing material is not suitable for all
wall types. Ask the retailer about the ap-
propriate screws and dowels for the respec-
tive wall conditions. The manufacturer as-
sumes no liability for improper wall-plug
connection and resulting damage.
Use
• The device is switched on with the I/O switch
movement, the red control LED will light up.
• Put the device into the bracket or onto a table or shelf. To place it on table, turn the
device 180° around. This will have no influence on the performance, as is the detec-
tion angle is 70° in all directions.
• Make sure that the motion sensor has a clear view of the area it is intended to cover.
• The test button
hear the ultrasonic sound, but the device will emit a functional test sound that is
audible to humans. Do not hold the device directly to your ear.
6. Specifications
• Frequency response: 20.000 – 27.000 Hz
• Detection angle: 70°, 7 m range
• Coverage: up to 7 m
• S ound pressure: 90 dB
• P ower supply: 6 x AA 1,5 V Mignon batteries (not included)
• P ower supply: DC 9 V, 100 mA
12
allows you to check, if the device is fully functioning. You cannot
. When the motion sensor recognises
Publicidad
