Publicidad
Idiomas disponibles
Idiomas disponibles
Before use
This Wet/Dry shaver can be used for
wel shaving with shaving lather or for
dry shaving
This walerproof shaver
can be cleaned in waler and used in
the shower Use warm water and shav-
mg lather to gel closer and smoother
shaves
Stan out shaving with gentle
pressure on your face You may genliy
Increase
the amoum
of pressure
as
your skin becomes
adjusted
lo this
Shaver
Applying
unnecessary
pres-
sure, however, does nol mean a closer
shava
Your Panasonic Wet/Dry shaver
re-
quires
a httle time
to gel used
to
Treat yourself to wal lather shaves for
at leasl three weeks and notice the dif-
ference
Your skin and beard
need
about 30 days lo adjusl to any new
shaving method
Parts identification
(ses fig 1)
Protective cap
Foil frame
Outer foll
Inner blade
Inner blade mount
Foil frame release button
On/off switch
Swlich lock button
Charge Indicator lamp
Pop-up Trimmer
Pop-up Trimmer swlich
Charging
adaplor wrih aulo-
matic voltage adjustment
Wall mount
Wood
screws
€) & (O O & &) & (m GODS
eue
How lo use Ihe wall mount
The chargmg adaptor can be hung on the
wall using Wood screws
1 Selecl appropriate location un Ihe wall
where screws can go In
2 Mounl the wall mount @ on the wall as
shown wilh the wand screws
(Making sure Ihat Ihe arrow paints up )
3 Slide charging adaplor groovas into the
wall mount & until it clicks in
To remove the charging adaptor from the wall
mount, slide the adapior upward
Charging (ses fig 2)
Charge the shaver fully for more than
eight hours before using à for the first
urne, or when il has nol been used for
more
ihan sh months
This shaver
cannol be over-charged
You can al-
ways slore your shaver in Ihe charging
adaplor ta maintain full power capacity
Before traveling, charge ^ fully for eighl
hours jf you do nol carry the charging
adaptor
Plug the charging adaptor into an AC
outlel, and keep Ihe adaplor level
Switch the shaver to the "0 = charge"
paston, and place il into the charging
adaplor with the switch facing towards
Ihe fronl The charge indicalor lamp
will glow red and d will slay on untl the
shaver Is removed from the adaplor Il
will adjust automatically to vollages be-
tween 100-120 and 220-240V AC
In
some
areas, a special plug adaplor
may be required
Using your shaver
After
the
shaver
has
been
fully
charged,
remove
the protective cap,
depress Ihe switch
lock button
and
slide Ihe OrvOff switch upward to tum
the shaver on
Using lighl pressure,
move Ihe shaver againsl Ihe direction
uf beard growth Always keep Ihe pro-
tective cap on the shaver when rl is nol
In use
|
Publicidad
