Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION (CONTINUED)
Installation Steps:
1.
Remove the pre-assembled window bracket panel adapter, hose, and hose connector from the package.
2.1
Remove the screws from the window kit
and screw in at the specified holes
(shown as below).
2.2 Adjust the window bracket per the width or
height of your window and tighten the screws
with a screwdriver to fix at the desired length.
There is a hole where the hose will be inserted
later. Make sure this hole is not blocked.
2 screws
Hole for Window Bracket
Panel Adapter and Hose
EN
4
Screw
Indoor
26.6", 36.2" to 50"
(67.5 cm, 92 cm to 125 cm)
Publicidad
