Hilti SL 2-A12 Manual De Instrucciones Original página 11

5.4 Pivoting the head of the lamp
1. Pull out the retractable hook.
When you suspend the lamp using the retractable hook, check the
load-bearing capacity of the point from which the lamp is suspended.
2. Pivot the head of the lamp upwards.
5.5 Turning the lamp head
▶ Turn the lamp head to the desired position.
The lamp head can be turned in either direction along the axis. Do
not attempt to force the lamp head past the end stops.
5.6 Switching on
1. Turn the lamp head to the desired position. → page 7
2. Select a mode by pressing the 3-mode switch.
6 Care and maintenance
6.1 Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance
tasks!
Care of the product
• Carefully remove stubborn dirt.
• Carefully clean the air vents, if present, with a dry, soft brush.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning
agents containing silicone as these can attack the plastic parts.
• Use a dry, clean cloth to clean the contacts of the product.
Care of the Li­ion batteries
• Never use a battery with clogged air vents. Clean the air vents carefully
using a dry, soft brush.
• Avoid unnecessary exposure of the battery to dust and dirt. Never
expose the battery to high levels of moisture (e.g. by being dipped in
water or left in the rain).
If a battery has been soaked by moisture, treat it as a damaged battery.
Isolate it in a non-flammable container and consult Hilti Service.
*2171356*
2171356 English 7