Husqvarna W 65P Manual De Usuario página 6

• Do not start the product if there is fuel or engine oil on
the product. Remove the unwanted fuel and engine
oil and let the product dry before you start the engine.
Examine the engine for leaks regularly. If there are
leaks in the fuel system, do not start the engine until
the leaks are repaired.
• Do not use your fingers to examine the engine for
leaks.
• Keep fuel in approved containers only.
• When the product and fuel is in storage, make sure
that fuel and fuel fumes cannot cause damage.
• Drain the fuel in an approved container outdoors
and away from sparks and flames.
Exhaust fumes safety
WARNING:
instructions that follow before you use the
product.
• The exhaust fumes from the engine contain carbon
monoxide which is an odourless, poisonous and very
dangerous gas. To breathe carbon monoxide can
cause death. Because carbon monoxide is odourless
and cannot be seen, it is not possible to sense it. A
symptom of carbon monoxide poisoning is dizziness,
but it is possible that a person becomes unconscious
without warning if the quantity or concentration of
carbon monoxide is sufficient.
• Exhaust fumes also contain unburned hydrocarbons
including benzene. Long-term inhalation can cause
health problems.
• Exhaust fumes that you can see or smell also contain
WARNING:
safety chapter before you assemble the
product.
To install the throttle control
1. Remove the cable tie.
2. Tighten the bolts with the screwdrivers.(Fig.20)
To select the correct hoses for the operatio
• Use hoses and hose connectors with a supplied
hose clamp.
• Make sure that the hoses cannot compress during
operation. The hoses must have a strong
construction.
Read the warning
Read and understand the
carbon monoxide.
• Do not use a combustion engine product indoors or in
areas that do not have sufficient airflow.
• Do not breathe the exhaust fumes.
• Make sure that the airflow in the work area is
sufficient. This is very important when you operate
the product in trenches or other small work areas
where exhaust fumes can easily collect.
Safety instructions for maintenance
• Take care of each error that you find on the product.
Speak to a servicing dealer if it is necessary and do
not operate the product if it is damaged.
• Incorrect maintenance or failure to do maintenance
on the product can cause malfunctions which can
cause serious injury or death to the operator or
others.
• Maintenance or servicing that is not given in this
operator's manual, must be done by an approved
servicing dealer.
• Do not do maintenance or servicing with the engine
on. Stop the product fully before maintenance or
servicing and let the engine become cool to prevent
burn injuries.
• Be careful around gasoline. Only use solvent that is
not flammable to clean the parts of the product. Keep
body parts away from hot fuel.
Assembly
• Make sure that the hoses are fully sealed and that
there are no types of holes in the hoses.
• Make sure that the suction hose aligns with the
dimension of the suction inlet. For information
about minimum hose dimension, refer to Technical
data on page 10.
• Make sure that the suction hose is not too long for
the operation to keep the best result. Obey the
instructions for operation of the product.
n
• Select a short discharge hose with a large diameter
to get the best result.
To install the suction hose
1. Attach the hose connector (A) to the suction hose
(B) with a hose clamp (C) . Make sure that the
WARNING:
Read and understand the
warning instructions that follow before you
do maintenance on the product.